国产色视频一区在线观看-少妇被按摩高潮在线观看-欧美大片黄片在线观看-久久婷婷综合激情亚洲

服務熱線: 400-117-8816
           13406879330

扭剪扳手,扭剪螺栓專用扳手,扭剪電動扳手,扭剪槍生產廠家

當前位置:首頁>新聞中心液壓扭矩扳手操作應該注意哪些?

液壓扭矩扳手操作應該注意哪些?

來源:http://csbdjy.com日期:2020-06-16 發布人:admin

在操作液壓扳手之前一定要檢查這些事項,然后才能操作液壓扳手。

Before operating the hydraulic wrench, you must check these items, and then you can operate the hydraulic wrench.
1、檢查電動泵的作業電壓是否滿足220V;電線是否滿足4個方。
1. Check whether the working voltage of the electric pump meets the requirements of 220V and whether the wires meet the requirements of 4 squares.
2、檢查高壓軟管有沒有出現折彎的現象,插頭插座上是否保持清潔;
2. Check whether the high-pressure hose is bent and whether the plug and socket are clean;
3、檢查液壓油泵的油標位是否在0線以上,液壓油是否清澈透明;
3. Check whether the oil level of the hydraulic oil pump is above line 0, and whether the hydraulic oil is clear and transparent;
4、一定要是專用液壓油,千萬不能混雜其他油。
4. It must be special hydraulic oil, and other oil must not be mixed.
操作過程中的注意事項:
Precautions during operation:
1、如果在取液壓扳手的過程中,出現扳手卡住取不下的情況時,應該按住按鈕不松手,并扳動快速釋放板機,然后松開按鈕,取下扳手;
電動扭矩扳手
1. If the spanner is stuck and cannot be removed during the process of taking out the hydraulic spanner, press and hold the button and pull the quick release plate machine, then release the button and take down the spanner;
2、如果帶有復位按鈕,液壓泵在起動之前要先按一下復位按鈕;
2. If there is a reset button, press the reset button before starting the hydraulic pump;
3、如果在試運轉的時候出現嘯叫聲,這時要把壓力調到,反復進行工作循環,直到把里面的氣體全部排完為止;
3. If the squeal occurs during the test run, the pressure shall be adjusted to the lowest level, and the working cycle shall be repeated until all the gas inside is exhausted;
4、正常工作的溫度為10-70°。
4. The normal operating temperature is 10-70 °.